wolfecc

Help cutting siser holograph

Recommended Posts

I am having no luck cutting the holograph from siser. I have wasted about 5 feet. I have got the blade the right height and when I put in the machine to cut it wont cut it all the way through, or if it does it rips as I try to weed it. Plus cant see to weed it. Any suggestions? What blade do you use? I have titan 2 cutter.

Share this post


Link to post
Share on other sites

I haven't tried the holographic.  I imagine it is about the same for this discussion as the glitter.  A 60 degree blade seems to work better with correct offset.  More force is needed, 180-200 grams seems to be my range.  Again, assuming it is like the glitter.

 

I mention this, because I did it once, make sure its not loaded upside down.

 

I have found that on HTV if you warm your press up to about 300 f lay the cut HTV on the press for about 5-10 seconds, but DON'T press, the warmed up htv weeds easier.

 

Instead of going for your final design, just cut a small circle or square at a time and weed it as a test until you hit the sweet spot.  Maybe even use the cutters test cut function.

 

Make sure the blade isn't sticking out too far from the holder.  

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now