wf2ste 11 Posted May 10, 2015 Hi guys, Looking for a bit of help, Had the cutter around 3 years now and not really had much trouble with it, but last week I had to move my computer (running xp) out of the way to test another system. After I had finished I placed my computer back and went to cut some designs, The cutter would just move a tiny bit and stop straight away. After fiddling with all the settings and re-installing the chaser drivers I tested my laptop, this works perfect so I went on to wipe XP from the computer and installed windows 7. I had the exact same issue with the cutter so I moved my main computer into the cutter room and replaced the old one, this started to work straight away so i presumed there was a fault with the older computer but as I came to weed the vinyl I noticed lines had been missed. I have now also done a complete re-install of windows 7 on the computer too but I still get the same result. I have attached a picture of what is happening (Look at the G) Any ideas what I could try? Share this post Link to post Share on other sites
wf2ste 11 Posted May 10, 2015 Fixed it now, was because it was connected via a usb3 slot 1 Share this post Link to post Share on other sites
SomethingNeue 0 Posted May 15, 2020 Hello. I've been having the same issues. Was your issue your connection? Your USB cable? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 15, 2020 8 minutes ago, SomethingNeue said: Hello. I've been having the same issues. Was your issue your connection? Your USB cable? That person has not been on here since 2016. Go back to your other post. Share this post Link to post Share on other sites