security802 686 Posted March 1, 2015 Just ordered my Titan2 today. Upgrading from a SC (which I still love) but want servo's for better fine detail. Should hopefully have by end of this coming week.. So excited beyond belief. :D 1 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 1, 2015 congrats on your purchase.. 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 1, 2015 congrats - it's going to be a bit heavier duty when you put that stand together than the old one - eat your Wheaties 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 1, 2015 can't remember why but I think the first time I put the feet on the stand on backwards - again can't remember if it was jacked up instructions or just me so think it thru when you put it together. much better built than your old one Share this post Link to post Share on other sites
security802 686 Posted March 1, 2015 Will do, Can't tell you how much I am looking forward to servo's Share this post Link to post Share on other sites
busterbay 326 Posted March 1, 2015 I have both machines, decals 24" and under cut the same the Titan is faster with complex designs. Over long distances the Titan is extremely accurate and 10x's quieter . Share this post Link to post Share on other sites
security802 686 Posted March 5, 2015 6hrs and I will be setting the titan2 up. It arrived today, too bad day job is in the way of getting it rolling now 2 Share this post Link to post Share on other sites
security802 686 Posted March 6, 2015 All up and Running, even had a rush job for tonight so it has even made it's first $20. So loving the servo's!!!! 4 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 6, 2015 little different? did you put the hearing protection away? 1 Share this post Link to post Share on other sites
security802 686 Posted March 6, 2015 little different? did you put the hearing protection away? Sorry what the silence is deafening... Oh the detail it does over the SC is awesome!! Time for me to shut it down and go to bed for day job, but I so do not want to lol 2 Share this post Link to post Share on other sites
pshawny 410 Posted March 6, 2015 You'll notice any out of place nodes in your old designs. I have an octopus design that I was amazed by the detail I was missing out on by cutting with stepper motors vs a servo motors. 2 Share this post Link to post Share on other sites