Sign in to follow this  
Tracy Daniel

Newbie from Louisiana...Need help getting my Titan 2 to run on Lexi Master Plus 10.5 Software, Thanks!

Recommended Posts

Okay so a couple years ago I brought a 31" Vinyl Express R-Series II Cutter/Plotter from Sign Warehouse, and upgraded all software to the Master Plus 10.5 version. Now in 2015, after so many problems with my original cutter from Sigh Warehouse, I purchased the Titan 2 from US Cutter w/ the SCAL PRO 3.

What I can NOT figure out is how can I use the Titan 2 with the LEXI MASTER SOFTWARE, and also SCAL PRO 3? I have been told that I can use the software with my new cutter, but I can not for the life of me, figure out why it doesn't pick up any info on the new cutter at all.

The Titan by far that I have seen thus far is GREAT, and it cuts unlike the funky R-Series Cutter. I do a lot of Race car designs, vinyl lettering & graphics, and really need to get this sorted out asap, since we are in the season for racing. Any advice, or help would be wonderful.

Here is my E-mail address, if needed : Tracydaniel@Luckymail.com

Share this post


Link to post
Share on other sites

The Titan 2 is a rebranded Saga vinyl cutter.  See if Saga is on the vinyl cutter list in LXI      LXI is made for Signwarehouse and their cutters and does not have all the frills of the full version Flexi products...

 

 

See if you can find anything here in the UScutter support....The Titan 2 set up should be there.

 

http://www.uscuttersupport.com/

Share this post


Link to post
Share on other sites

I might add...do not use serial or attempt to use it. The Titan has REAL USB and that's all you need.

Share this post


Link to post
Share on other sites

check your email -  instructions sent to add your cutter to your ve-lxi program - it is the same instructions as for flexi exept the folder will be signwarehouse instead of sai or flexisign

Share this post


Link to post
Share on other sites

and what john said I used mine with the usb - it doesn't have the emulation chipset like the cheaper cutters (ie your old redsail)

Share this post


Link to post
Share on other sites

Hello, I saw that you had emailed the information to the previous member. Would you be willing to email me that information as well?  We have ben going crazy trying to get it to link up... 

 

Taylor@harrisell.com

Share this post


Link to post
Share on other sites
Hello, I saw that you had emailed the information to the previous member. Would you be willing to email me that information as well?  We have ben going crazy trying to get it to link up... 

 

Taylor@harrisell.com

are you using ve lxi program as that is what the instructions are for

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this