joefraga 3 Posted January 27, 2015 Any help is appreciated. Share this post Link to post Share on other sites
Cal 393 Posted January 27, 2015 I don't know about a font, but I cannot even read it. Is it a word? What does it say? Cal 1 Share this post Link to post Share on other sites
joefraga 3 Posted January 27, 2015 LOL took me a bit to figure out what it said also. But Slice&dice is correct. Share this post Link to post Share on other sites
mark-s 1,126 Posted January 27, 2015 Just vector it and be done. mark-s Share this post Link to post Share on other sites
skarekrow 1,842 Posted January 27, 2015 Flip it over and it reads "DEATH". (ambigram) 4 Share this post Link to post Share on other sites
joefraga 3 Posted January 27, 2015 Wow Skarekrow, thats creepy. Sorry Mark. Dont know how to Vector it. Can you point me in a direction to learn how to do that? Is that what you did Skare? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted January 27, 2015 Inkscape.org is FREE software.. Follow instructions below https://inkscape.org/doc/tracing/tutorial-tracing.html Share this post Link to post Share on other sites
skarekrow 1,842 Posted January 27, 2015 Dig around a little for "vectoring"... There's plenty of info available. LifeDeath.svg LifeDeath.eps Share this post Link to post Share on other sites
dwp99 283 Posted January 28, 2015 Thanks Skarekrow grabbed one. Share this post Link to post Share on other sites