Sign in to follow this  
grajuiceki

write port error

Recommended Posts

i send a file to my sc model 34" plotter and half way thro the cut it says write port errorand stops cutting 

 

bps: 9600

data bits : 8

parity : none

stop bits : 1

flow control : hardware

[RTS] [CTS] these are the checked boxes

someone please help me with this

Share this post


Link to post
Share on other sites

  Which Flexi are you using, on what operating system?     Make sure the com port numbers match in Flexi and your computer device manager.

Share this post


Link to post
Share on other sites

Well if it is cutting, and stopping,, It could be static, or too much data for the cutter (low memory)...If on USB connection, best to run on a serial connection.  or serial card.. A Tripplite Keyspan adapter is recommended for the value cutters such as an SC...Or a Belkin.. most others from Radio Shack, Best Buy etc, just don't do the job.    Will the cutter finish the job if you take the blade holder out before cutting?  If it does finish, then it could be static.  Make sure your cutter is grounded to the stand, Spray Static Guard in the area...wipe vinyl  and cutter with dryer sheets..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this