Jburns 239 Posted December 11, 2014 Hi all, Anyone have experience with Graphtec Studio? My cutter is recognized and listed on the right side. However when I send a job the status on the computer says " Status: Syncing". and nothing happens. Driver installed OK for USB, Cutter set to GP-GL. Cutter Shows Condition 1...Ready. the Cutter also shows up listed in my software. For kicks, I tried signblazer to no avail (even in HP-GL mode). Test cuts at the cutter perfom just fine. Share this post Link to post Share on other sites
skarekrow 1,842 Posted December 11, 2014 Sounds like an issue with either Port settings in windows, or Bad USB cord. How are you sure your USB driver is "OK"? Share this post Link to post Share on other sites
Jburns 239 Posted December 11, 2014 just solved minutes ago. i had to assign the driver to the Graphtec FC7000- and place in printers area under devices and printers. Of course user error 1 Share this post Link to post Share on other sites