Englishman 0 Posted November 22, 2014 Has anyone else had this problem ? We set the job up in CS3 and select the cutting conditions in there - we use 2 conditions - 1 for contour & 1 for perf . About 50% of the time after it's finished contour cutting and tells us to switch blade positions from 1 to 3 for the perf operation ( which we do ) instead of perf cutting the job correctly it starts to perf cut the graphic then immediatly just cuts a perf line back to the initial registration point. See picture. Help ! Share this post Link to post Share on other sites
