CajunCustom 29 Posted November 7, 2014 I have a Titan 2 , tonight i was cutting a 3 part file , i didnt notice but i had it a little too big , so i figured i would finish all the cuts cause i could still use them , so i resized the same file send to cutter and i have no clue what happened but it like double cut it cut the new smaller version and the older bigger version , so i changed nothing and set it to cut again and then it was fine ? what gives ? Share this post Link to post Share on other sites
PhaedrusZen 55 Posted November 7, 2014 That's no bueno. I imagine that's a software issue more than a cutter issue. Are you using SCAL? Share this post Link to post Share on other sites
CajunCustom 29 Posted November 7, 2014 Vinyl Master v4 Pro , ho no issues after that cut the same file over and over no problem it was wierd Share this post Link to post Share on other sites
Jburns 239 Posted November 7, 2014 Perhaps a duplicate message to the cutter, or accidental duplicate while resizing? Share this post Link to post Share on other sites
CajunCustom 29 Posted November 7, 2014 Thanks for the insight , im still very new to this so it kinda threw me for a loop Share this post Link to post Share on other sites
