simplyme 0 Posted November 4, 2014 Just recently I tried to use my Signblazer and it wouldn't work, telling me the cutter was unavailable. After snooping around I found that the com port had somehow been changed. Of course by this time I had tried several other things and changed the printer (since Signblazer does not recognize my UScutter Laserpoint). NOW, when I go to cut a design it is mirrored and lays across the vinyl perpendicular to what it is supposed to. Also, when done, the cutter does not return to the start of the next design but stays at the end of the design. Can anyone help me change this back? Donna Share this post Link to post Share on other sites
BearlyRich 167 Posted November 4, 2014 What did you change your cutter to in SB? If you have the original Laserpoint (not the 2), then you would select the Creation P-Cut CT as your cutter. The numbers after the "CT" such as '900' are the size (width) of the cutter. If you have the 24", select the CT630. See if that fixes things... Share this post Link to post Share on other sites
simplyme 0 Posted November 4, 2014 Thank You!!! That's the ticket!! I knew something was off but not sure what. Share this post Link to post Share on other sites
BearlyRich 167 Posted November 5, 2014 Glad to hear you got it working again. And glad I could help someone for a change Share this post Link to post Share on other sites