Capt'n Morgan 54 Posted October 15, 2014 Getting involved in this Vinyl Cutting thing and the related Off Shoots of this has given me a NEW FOUND respect for all Of you folks. I have been busy learning the Vinyl end and glass etching end with good success. I moved onto Sublimation of Coffee Cups 11 oz size useing 3 1/2" X 9" Sub Stock. I go into Corel and make a 3 1/2" X 9" Layout Insert Picture and Text in it go to print and Its all Jacked up Only prints about 1" of the bottom part of my layout across the top part of the Sub Paper. Is there a template I am suppose to be using? I am useing EPSON 1430 printer Cobra Ink with proper profile setup just cant get it to print right. Thanks ~Duke Share this post Link to post Share on other sites
KYSIGN 233 Posted October 15, 2014 I would make the document size the size of your paper and then make a square the size of your design with a little extra for a bit of overprint. 4 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 15, 2014 like he said make sure to select the right paper size on your printer when you print it 1 Share this post Link to post Share on other sites