Sign in to follow this  
han7681

after factory reset, doesnt work !!!!

Recommended Posts

hi
done factory resetting , but once power on , some weird things show on the screen , as below



it is supposed to be 1st photo ,

any idea why?

it may be cable problem? slightly damaged when it was pulled off.

where i can this cable?

thank

post-6396-0-49874300-1410702451_thumb.jp

post-6396-0-78240200-1410702464_thumb.jp

post-6396-0-89009400-1410702474_thumb.jp

post-6396-0-63081600-1410702483_thumb.jp

Share this post


Link to post
Share on other sites

The third wire from the left looks like it may not make contact...US cutter may have the part for you to order. Have you tried downloading manual from graphtec website? It may have error codes listed.

Share this post


Link to post
Share on other sites

Many sold on EBAY  Easy to do a search of the number on the cable.   What was the original problem that you did a factory reset and tore into your vinyl cutter..? 

 

  http://www.ebay.com/sch/i.html?_nkw=awm%2020861%20105c%2060v&clk_rvr_id=100000453748554&adpos=1t1&MT_ID=69&crlp=17210914883_2416792&device=c&geo_id=10232&keyword=awm+20861+105c+60v&crdt=0

Share this post


Link to post
Share on other sites

Judging from the pics, you appear to have some technical knowledge or possibly a sense of adventure. You could always trim the cable end and restrip the contact points if you believe that's the problem.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this