Chuckle monkey 1 Posted August 15, 2014 I want to make some can Koozies for a friend and I cant seem to get this to come out good. using SCALP. Any suggestions would be greatly appreciated. Share this post Link to post Share on other sites
Chuckle monkey 1 Posted August 15, 2014 Here is what i got. FLA Logo White.EPS Share this post Link to post Share on other sites
slice&dice 2,450 Posted August 15, 2014 Here's what I discovered --- (I'm using SignBlazer, but the same process probably will work for you in SCAL) After importing the .eps, Select it all (CTRL + A) and then Combine Objects, and then Weld. That worked for me, leaving me with a clean cuttable file. Share this post Link to post Share on other sites
30-284 86 Posted August 15, 2014 Is this what your looking for? your logo with out the black square. flat line.svg Share this post Link to post Share on other sites
mb20music 760 Posted August 15, 2014 Here it is in .eps file format fla_logo_new.EPS Share this post Link to post Share on other sites
express2100 154 Posted August 15, 2014 I like the concept but imo it could use some work. The flight end of the arrow isn't proportionate to the broadhead and I think it would look better with some separation around the "archery" with some shaft before the broadhead. ....constructive criticism Share this post Link to post Share on other sites
Chuckle monkey 1 Posted August 15, 2014 Thats what I needed. Thanks so much guys!!! Share this post Link to post Share on other sites
slice&dice 2,450 Posted August 16, 2014 Well, once more, the USCUTTER Forum hits the bullseye !!! Share this post Link to post Share on other sites