MH 365 with SignCut Pro on Max OSX 10.9.3 Help!

[tungtle 0]

So I previously had my MH 365 running fine on my 2 year old MacBook Pro, but I recently got rid of it.  I now have a 2013 27" iMac and a 2014 MacBook Air.  

 

I installed the Keyspan Driver.

 

And set the SignCut settings to

 

USCutter

 

USCutter Refine MH365

 

Keyspan Port

 

Baud at 4800

 

once I hit cut, it doesn't do anything, and then it seems like the software is crashing, I end up force quitting the signcut software and try doing it again, but nothing.  Any help??

[MZ SKEETER 4,709]

From UScutter site

 

The MH Series Vinyl Cutter is available in 14", 28", 34", and 50" sizes. Cutter not Compatible with Mac.

[tungtle 0]

I purchased this MH 365 close to 2 year ago, and back then it said it was Mac compatible.  The weird thing is that used to work just fine.  But thats when I was on Mountain Lion.  I'm now on Mavericks and not sure if that is the reason why.  

[MZ SKEETER 4,709]

I purchased this MH 365 close to 2 year ago, and back then it said it was Mac compatible.  The weird thing is that used to work just fine.  But thats when I was on Mountain Lion.  I'm now on Mavericks and not sure if that is the reason why.  

Contact tech support

[Moody Blue 505]

See if there is a new updated driver for Mavericks. I had to call and get the new drivers emailed to me last year when I upgraded from cutting off a Macbook Pro with Mountain Lion to my new iMac running Mavericks. I use Sign Cut also but that wasn't the issue...it was the actual plotter not able to communicate properly with the computer. 

[tungtle 0]

Hmmm that might be the issue, I'll contact them, thank you

[tungtle 0]

See if there is a new updated driver for Mavericks. I had to call and get the new drivers emailed to me last year when I upgraded from cutting off a Macbook Pro with Mountain Lion to my new iMac running Mavericks. I use Sign Cut also but that wasn't the issue...it was the actual plotter not able to communicate properly with the computer. 

 

so the tech gave me a link to a keyspan driver that I already have, still doesn't work.  Do you happen to have that driver still?

[MZ SKEETER 4,709]

so the tech gave me a link to a keyspan driver that I already have, still doesn't work.  Do you happen to have that driver still?

The poster above does not have an MH series cutter like you do...  His cutter is Mac compatible.

[tungtle 0]

Well my MH gen 1 was compatible, but with Mavericks, a no go.  Might trying to find a friend with an older OS

[Moody Blue 505]

Well my MH gen 1 was compatible, but with Mavericks, a no go.  Might trying to find a friend with an older OS

 

no fun 

[BannerJohn 1,324]

you should be able to find an older OS cheap...create a partition,and dual boot.