JUSTCREATIVE 0 Posted July 22, 2014 Hello everyone, I been tring to figure this out since I received the machine. I'm using sure cuts alot 3 and the uscutter 53'' sc and the contour is not lining up correctly even after calibration and going through all the steps. I tried creating my own registration points and came close but not the results that I want. If anyone has any information on how to fix this and contour cut with the sc I would greatly appreciate it. - Thanks Share this post Link to post Share on other sites
Brandiland 5 Posted January 30, 2016 This is my problem too. Did anyone help with this? Share this post Link to post Share on other sites
