Sign in to follow this  
krissyjessop

Last few inches of cuts are off - HELP

Recommended Posts

I have a Copam CP-2500 cutter... the last few times I've used the cutter, the text is "off" at the end of my "sayings". Kinda of hard to explain so please see attached pic. After OF, the next section of the saying is raised higher. That's not how I have it in the Sure cuts software. Not sure why it's all of a sudden doing this but I need it fixed ASAP. 

Please advise! 

THANK YOU

post-86925-0-68646300-1402264506_thumb.j

Share this post


Link to post
Share on other sites

What direction is the text in relation to the cutter? Is the picture what you would see if standing in front of the cutter?

Share this post


Link to post
Share on other sites

Yep, been there and done that myself. I was cutting fine sand then slid my pinch roller over to where it wasn't over a friction spot on the drive shaft and everything went real bad.  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this