reeves1985 2 Posted June 3, 2014 Having a major issue with sign cut and my pcut I have everything set up so it works but signcut will never complete a full job it just stops 3 quarters of the way through and goes back to the "online" state My plotter is directly connected through USB with correct updated driver installed Initially to get the plotter to cut I had to set the baud rate to 38400 and every job which fails in signcut finishes complete and correctly in signblazer so my plotter is communication with my computer It doesn't matter if the job is a large one or small one in signcut it will still fail A side not I couldn't get my plotter and pc to communicate with any other baud rate including 9600 I don't have a serial port so that is out of the question at the moment Any help appreciated Thanks Share this post Link to post Share on other sites