Guest Terry

ROLLING GRAPHICS ?????

Recommended Posts

Guest Terry

I made a racing graphic for a friends trailer, and when I put the transfer tape on it rolls up with kinks in it??? How the heck can I mail it in a tube? Send him the tape to apply  ;D

Share this post


Link to post
Share on other sites

This is normal... Try not to Roll it too tight.  Also, I have found it best to roll the graphic with the graphic on the out side, and the backing paper on the inside. (flip it over to roll it up) It will need to be re-squeeged when it is at the location before installation.  And also probably laid flat for a few hours to elimated the curlness.

Share this post


Link to post
Share on other sites
Guest Terry

Thank you Tater, I thought maybe I was doing it wrong. I'll flip it and try.

                                                      Thanks

Share this post


Link to post
Share on other sites

Some of the vinyl decals I used to receive in the mail were often rolled like explained above, the graphic on the outside. These ended up working ALOT better than with the graphic rolled on the inside because it had less creases. All I did was re-squegee them a bit and they ended up looking perfect.  ;D

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now