fedjastacey 8 Posted May 21, 2014 Hiya. I have a 1200mm sc1261e liyu cutter. I set it up via a USB to serial and using a serial cable and everything was working great even up to last night and then today cutting the same stuff I was cutting last night it's gone horribly wrong I'd do everything as normal. The cutter would start cutting as it should. On signcut the timer green back seems to shoot forward and complete time Hangs around 10 seconds and then before a minute into the cut the cutter returns to where it started and does a weird cut at the bottom and just stops. The display on the cutter says "now is cutting". Anyone know what could be causing this? It's so strange and wastes a lot of vinyl 1 Share this post Link to post Share on other sites