express2100 154 Posted April 19, 2014 Looking for something simple and ready to cut. I have tried to trace a few with poor results. The designs are too busy and end up blotchy. Thanks Share this post Link to post Share on other sites
dwp99 283 Posted April 19, 2014 Here's one I found but you might have to do some node editing. Power Trowel.eps Share this post Link to post Share on other sites
express2100 154 Posted April 19, 2014 Thanks but it is solid black when I open it in Graphtec Studio. It shows normal detail in the preview folder but all black when opened. I have had this issue with a few others as well. What causes it? Is there a remedy? Share this post Link to post Share on other sites
jaybyrd 3,770 Posted April 19, 2014 Check to see if there is a box drawn around the whole image. That may cause it to look black when you open it. Share this post Link to post Share on other sites
dwp99 283 Posted April 19, 2014 I was going to say try unmasking or uncompounding it. I just downloaded and tried it in Flexisign works fine. Share this post Link to post Share on other sites
skarekrow 1,842 Posted April 19, 2014 These should work for you... Power Trowel.svg Power Trowel.eps Share this post Link to post Share on other sites
express2100 154 Posted April 19, 2014 I was going to say try unmasking or uncompounding it. I just downloaded and tried it in Flexisign works fine. have no unmask or uncompound Share this post Link to post Share on other sites