joey414 1 Posted April 13, 2014 I bought a k40 III laser engraver months ago on craigslist. I got the engraver, fan system, water pump, a dongle and software. When I tried loading the software it would not load and found a crack in the disk. I contacted the company in china about the software but was told that being that I didn't buy from them I couldn't get the software. I know that the engraver works because I engraved some with my sign blazer. The only problem was it didn't cut the laser off when moving from one letter or object always connecting them with a line between. Does anyone have any suggestions. Share this post Link to post Share on other sites
Vermonster 111 Posted April 13, 2014 What's the name of the software? Share this post Link to post Share on other sites
mark-s 1,126 Posted April 13, 2014 I was reading that Corel will work with laser machines. mark-s Share this post Link to post Share on other sites
mb20music 760 Posted April 13, 2014 Is it Moshidraw software? http://www.moshidraw.com/EnProductShow.asp?ID=96 Share this post Link to post Share on other sites
joey414 1 Posted April 13, 2014 It came with newly seal Share this post Link to post Share on other sites
rich18 2 Posted April 14, 2014 Corel does drive ( directly ) a number of items. Vinyl Cutters - Lasers - and from my OWN experience, it will run New Hermes / Gravograph and Roland engravers , by using a standard HPGL / Graphtec CE1000 / 2000 driver. I even have it running my recently purchased MK2 cutters DIRECTLY with the MH MK2 driver. I have used Corel as my ONLY sign cutting / engraving software for 12 years ! It is much better than any others I have experienced. Convert your text / graphics to hairline outlines - no fills - convert to curves .... and GO ! It may very well run your engraver as well, since just about EVERY other software is a modified copy of Corel. Richard A-1 Quik Signs Woodruff, SC SignTrainer.com Share this post Link to post Share on other sites