rglazer 0 Posted April 5, 2014 I just got my LaserPoint II cutter today and connected it to my Windows 8 laptop. Installed drivers from the SCALPro disk and the LP2 showed up as a unspecified device in Printers and Devices. SCALPro didn't detect it at all. So I bought a Dynex USB-to-Serial cable and it still didn't show up. So I connected it to my Windows 7 laptop and installed the drivers from the SCALPro disk and the LP2 failed to show up as a device. Am I missing something here? I even tried older Vista drivers and the COM port was 1 and then I tried COM4. No luck. I would think this cutter should be plug and play. Any help appreciated. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 5, 2014 2 things install the USB drivers for the fetdi chipset . . . Second is the dynes converter is not like a true key span adapter Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 5, 2014 http://www.uscuttersupport.com/downloads/Support_PDF/USBSetup/LP2/LP2_USB_Win7.pdf Share this post Link to post Share on other sites
rglazer 0 Posted April 5, 2014 Thanks for your help. Got it to print. Shame about the Dynex though.... Will buy an actual Keyspan now Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 5, 2014 I could never get my cutter to print 2 Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted April 5, 2014 I could never get my cutter to print I would think that would be real messy,,, 2 Share this post Link to post Share on other sites
skarekrow 1,842 Posted April 5, 2014 Bugs me a little to see that written, as well. 1 Share this post Link to post Share on other sites
