cescor 0 Posted April 2, 2014 Hello! I'm new Signblazer elements user, and I have a "little" probleem. If I try to cut a print, it does't cut right. Directions of cutting are 1cm on the left and 0,5cm down. (about the originaal image) Quite hard to explane, but i hope somebody will understand. (cutter 721MH) Greetings from Estonia! Share this post Link to post Share on other sites
slice&dice 2,450 Posted April 2, 2014 I had to look up Estonia on a map. To my way of looking at it, your tiny country is the next in line to be gobbled up by Russia. Anyway, to answer the question, in the cutting screen, there's a checkbox that says "Fit to Origin" and it needs to be selected. Share this post Link to post Share on other sites