fedjastacey 8 Posted March 22, 2014 hey guys. I am new to vinyl cutting and am still learning With my cutter I got given some spare rolls of vinyl and most of them were avery not sure what thickness tho but I had very miniman problems using that even printing quite busy lettering Then I ordered some cheaper stuff which is £10 for 5m 610mm off ebay and immediately noticed to touch it feels very different to avery and it's a lot thinner. Upon a test cut it was cutting through too thin. So I adjusted the blade and made it as small as I could and it cut sort of ok and weeding and peeling was real easy However during the cutting process on some lettering the vinyl would start to come off and peel a bit and I'd have to push it back by hand Is there any suggesting and ideas how to stop that happening Thanks in advance for any help Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 22, 2014 Try oiling your blade holder and check for small pieces hiding in the holder Share this post Link to post Share on other sites
fedjastacey 8 Posted March 22, 2014 <blockquote class='ipsBlockquote'data-author="dakotagrafx" data-cid="349853" data-time="1395530108"><p> Try oiling your blade holder and check for small pieces hiding in the holder</p></blockquote> Thanks dude. Will try When you say oil it do u mean open the holder and put the oil in where the blade is held? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 22, 2014 Yes some lightweight oil like 3 in 1 , sewing machine, reel oil etc Share this post Link to post Share on other sites
fedjastacey 8 Posted March 22, 2014 Thank you. I will give it a shot Share this post Link to post Share on other sites