ajr2820 0 Posted December 12, 2013 I just moved up from an MH-721 to the CE5000-60 and so far, so good. One thing I haven't figured out yet is that when I cut with the MH-721, the cutter would finish and advance slightly; leaving the freshly cut job sticking out of the machine. The CE5000 returns to the origin. Is there a way to change this in the settings? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted December 12, 2013 change the settings in your cutting software to advance after cut Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 12, 2013 what cutting software? But right, that feature is in the cutting software. Congrats on the great purchase of the Graphtec. 1 Share this post Link to post Share on other sites
mb20music 760 Posted December 12, 2013 If you are by chance using SignBlazer, go into the cutter setup menu and select "Advance Page After Job" and you can also adjust the amount of the gap in the box below. Share this post Link to post Share on other sites