marduk 0 Posted November 25, 2013 @mr300s Tryed with Oracal 638 with the same result. Good suggestions tho. Also tryed lowering the speed to 5 and below. The belt is curving, since the carriage is lifting it up. Is that normal? http://i.cubeupload.com/eaNFD2.jpghttp://i.cubeupload.com/mgJwxw.jpg Share this post Link to post Share on other sites
jaybyrd 3,770 Posted November 25, 2013 I just moved my carriage back and forth by hand and the belt stayed straight, nothing like yours is doing. Share this post Link to post Share on other sites
marduk 0 Posted November 26, 2013 Any suggestions? Not sure how to get the two roller on each side to be higher and the belt thats going through the carriage, doesnt doesnt seem as if it could get any lower in there. So the only thing i can think of, if the carriage could get further down? Share this post Link to post Share on other sites