dplovin 1 Posted September 6, 2013 I'm using a creation pcut ct630 with flexistarter 8.5 I've been cutting vinyl with no problem for weeks. But all of a sudden today I'm sending my design from flexi to my cutter but no response. First it says holding then counts up to 100% on flexi but no response from cutter Any ideas Share this post Link to post Share on other sites
BannerJohn 1,324 Posted September 6, 2013 check your ports....I have seen (more than once) the ports change randomly. Share this post Link to post Share on other sites
dplovin 1 Posted September 7, 2013 Cheers matey ill give that a try Share this post Link to post Share on other sites
dplovin 1 Posted September 7, 2013 Cheers matey ill give that a try Share this post Link to post Share on other sites