solantis 0 Posted August 24, 2013 Why is it that when I load material onto my Roland VP540 it gives a width smaller than the actual material? For example I loaded a roll of vinyl which is 1260mm and it says 1129mm? Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted August 24, 2013 I believe it's due to the rollers. . I'm sure some one way more knowledgable will chime in. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 25, 2013 it reads the width of the pinch rollers on the outside - there are magnets in them -I lose about 1 to 1.5" on the same thing Share this post Link to post Share on other sites
