mwhatch 9 Posted June 3, 2013 Here is the pen I made with the vinyl cuts I showed previously. I call it "Faux Steampunk", the pen is a Wall ST II Click, if there are any other pen makers out there. Thanks for looking. Morton 1 Share this post Link to post Share on other sites
Ravenwind / One Off Grafx 187 Posted June 3, 2013 Looks great Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted June 3, 2013 That's cool. Share this post Link to post Share on other sites
dennismc42 12 Posted June 3, 2013 Nice work,Are you just wrapping the barrel in the vinyl then casting it in clear acrylic? Dennis Share this post Link to post Share on other sites
mwhatch 9 Posted June 3, 2013 Thanks for the comments. Dennis, on this one I wrapped with vinyl, then applied a CA finsh, then the details, then more CA, sand and polish. Casting in PR tends to wrinkle and lift the vinyl, probably from the heat. Thanks for looking. Morton Share this post Link to post Share on other sites
dennismc42 12 Posted June 3, 2013 Good point on the casting, didnt think of the heat.I guess its time to fire up the lathe again some now that I am cutting vinyl. Didnt think to use it for the pens! Share this post Link to post Share on other sites
mwhatch 9 Posted June 3, 2013 That is the main reason I got the Cameo, to see if I could use it to embellish my pens. I have been really happy with it so far. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted June 3, 2013 Looks good. Lots of detail Share this post Link to post Share on other sites
security802 686 Posted June 5, 2013 mwhatch, where did you get your pen display that is cool Share this post Link to post Share on other sites