huntrjo 4 Posted May 30, 2013 I just received two 48" rolls of white reflective vinyl in the mail from 3M and I only have 24" cutters. Is there any way to cut it down so I can use it? Thanks for any help. Joey Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 30, 2013 chop saw or a hack saw. 1 Share this post Link to post Share on other sites
Wildgoose 4,200 Posted May 30, 2013 Mz Skeeter is right. I would take a utility knife and cut through all the way around then maybe unroll it onto an old tube or something. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 30, 2013 I have cut a lot of vinyl with the power miter saw with no problems - wish I had 1 more of the window perf sample from them - the rolls are very very expensive when you buy the whole roll and have it slit - Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted May 30, 2013 They sent me a roll of their metallic blue and I didn't expect it. I thought I asked for a sample of red but it was the wrong company. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 30, 2013 They sent me white reflective which happens to be the same reflective used on our sheriff cars and one of the local garages does their bodywork and I fix the graphics for them when needed so that sample made me quite a bit of money 1 Share this post Link to post Share on other sites
Jay2703 704 Posted May 30, 2013 Chop saw works amazingly well. I wouldn't have believed it if I hadn't done it myself. Share this post Link to post Share on other sites
huntrjo 4 Posted May 30, 2013 Thanks for all the answers guys. Yeah I wasn't even expecting it they sent me two rolls of the white reflective. But thanks again. Joey Share this post Link to post Share on other sites
huntrjo 4 Posted May 30, 2013 Thanks for all the answers guys. Yeah I wasn't even expecting it they sent me two rolls of the white reflective. But thanks again. Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted May 30, 2013 I heard chop saw is the best I haven't had to do it yet but now that I think out it I may need to with the metallic blue. Share this post Link to post Share on other sites
xJoey Dubsx 42 Posted May 30, 2013 Wrap it tight with masking tape where you plan to cut it, my .02 1 Share this post Link to post Share on other sites
huntrjo 4 Posted June 10, 2013 Chop saw worked flawlessly. 1 Share this post Link to post Share on other sites