dh designs 1 Posted May 18, 2013 ok first off I have a laserpoint cutter and have been running it on signblazer for a while now so this is not my first cutter. Anyway my problem is I just bought a used SC cutter my plan was to use this as a backup or to take it to events and use onsite, so I loaded signblazer on a laptop and set it up hooked the SC to it and go to cutting, the only problem is the cutter is cutting in "mirror" when the signblazer is set to normal and when I switch the sighblazer to mirror it cuts "regular" is there something in the SC that I can change to fix this ?? Thanks Danny Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 18, 2013 Hopefully you are using the Liyu driver...You don't state Share this post Link to post Share on other sites
dh designs 1 Posted May 18, 2013 using the driver off of uscutters sight, not sure about if its liyu or not ? Share this post Link to post Share on other sites
dh designs 1 Posted May 18, 2013 so I figured out what was wrong. I set it up like was said on the uscutter site they say to select one of the pcut settings but after the above post saying liyu driver I looked on the list and well liyu was there so I selected it an now good to go..... 1 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 18, 2013 there ya go.....FIXED.... Share this post Link to post Share on other sites
