Sign in to follow this  
Ericjgidney

Cutter Issues?

Recommended Posts

I could use someones help. I usually have no issues cutting graphics but when it comes to cutting the raiders logo it pulls off vinyl while cutting. I changed blade offsets, changed blades, changed angle blades, changed vinyl both thicker and thinner and nothing seems to work. This is for a small project like a 4x4 picture. This would not be an issue for a decal but I am using for etching and so it eats the things I need to keep. Sorry and the cutter is an sc model

Share this post


Link to post
Share on other sites

usually lifting vinyl is caused by too much blade.  Also clean that blade now.  with alcohol, to get all the adhesive off of it.

  • Like 1

Share this post


Link to post
Share on other sites

Probably your design has fine / small details -- go into your design and check the nodes.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this