virus-found 1 Posted May 1, 2013 hey guys i have a us cutter mh 721-mk2 some times it will work great an some times while cutting jobs the display will go blank an and then come back on an rests or even on standby before i send jobs to cut it will do the same thing juss go blank an come back on what can cause this problem ? here is a youtube link so you can see for yourself Share this post Link to post Share on other sites
GraphxNMore 282 Posted May 1, 2013 Did you ground the cutter to the frame of the stand? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 1, 2013 try pushing in the reset button(s) on the side frame , maybe stuck Share this post Link to post Share on other sites
virus-found 1 Posted May 1, 2013 Did you ground the cutter to the frame of the stand? yes it is grounded correctly... Share this post Link to post Share on other sites
SeeJaysPlace 476 Posted May 2, 2013 i would say bad motherboard.. Share this post Link to post Share on other sites
slice&dice 2,450 Posted May 2, 2013 Hmmmmmm, Trinidad & Tobago. I am going to take a shot in the dark here and say that you have a POWERLINE issue. In my humble opinion, the mains voltage is not staying consistent, and is either surging or dropping. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 2, 2013 I seem to remember someone else having that problem and the button skeeter referred to was sticking or bad Share this post Link to post Share on other sites
virus-found 1 Posted May 23, 2013 I seem to remember someone else having that problem and the button skeeter referred to was sticking or bad where is this button located ? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 23, 2013 on the side of the vinyl cutter.frame Your carriage head travels left and right. and , resets are there for the carriage head to touch. Share this post Link to post Share on other sites
Conquestgraphics 4 Posted May 24, 2013 The mk-2 does not have a red rest button like the older mh721 Share this post Link to post Share on other sites