angelamapps 0 Posted February 19, 2013 I just got my USCutter Model SC Plotter today, read through all of the manuals watched all the videos and put it together. Got up to the part where I am to plug the machine in and turn it on. The vedio indicated that the carriage would move to the right and stop at its starting point. Upon turning on my machine the carriage definately went to the right hand side but it didnt stop. It acts like it wants to run through the side and keep going. What do I do? It also is making this awful grinding noise while it is pushing against the side wall. PLEASE PLEASE IF ANYONE KNOWS HOW TO MAKE T STOP... Thank You Angela Share this post Link to post Share on other sites
xpaperman 719 Posted February 19, 2013 I would guess there is something wrong with a limit switch. Could be misaligned, broke, not installed or have a loose wire to it. I would call customer support and chat with them. Might be an easy fix over the phone. I am sure someone with a little more knowledge than me will chime in shortly tho. Share this post Link to post Share on other sites
angelamapps 0 Posted February 20, 2013 FIXED IT!!!!!!! Just had to take the bottom off and the little green stopper button wire was disconnected from the mother board. Thank you so much xpaperman for your response. Have a great day !!!!! Share this post Link to post Share on other sites
