Wildgoose 4,200 Posted February 10, 2013 I have been messing around for a while and can't find if there is a way to change the orientation on the rulers on the cutting mat. My cutter cuts from the lower right hand corner but the rulers are set from the upper left. It would be nice to have the rulers start where the cutter starts. There is very likely somewhere to do this but I have yet to find it. Share this post Link to post Share on other sites
Rodger 527 Posted February 10, 2013 I have looked for that also . I don't think that is an option ?? There is a setting in the cut screen under " Cut Mode " ... 1 is " Origin " , where it automatically puts the design to where the cutter starts ( saves vinyl & a NICE option that is an easier cutting alignment than any other software I have tried ) & the other is " WYSIWYG " , where it cuts the design as it appears in the mat . Share this post Link to post Share on other sites