bryguy39 0 Posted January 24, 2013 My machine will only cut up and down, will not move to the left. I called support and they told me mother board was shot, replaced it with a new one and same thing, i can get it to move the rollers back and forth and to the right but not to the left, can somone give me some ideas on what it could be? Thanks,Bryan Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted January 24, 2013 I would call support since you spent the money on a motherboard on thier advice - let them troubleshoot it. Share this post Link to post Share on other sites
fitbmxseries1 1 Posted January 28, 2013 Just got mine on friday and its doing the same thing. Im sending it back today and hopefully they can tell me what the issue was and I can fill you in. Share this post Link to post Share on other sites
fitbmxseries1 1 Posted January 30, 2013 It was the green kill switch that stops the carriage from going to far to the left. Pull the 4 screws off the top rail and adjust the rail so it doesn't hit the switch and trigger the stop. Test it with the top cover off. 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted January 30, 2013 DOH - new motherboard cost - and it is the kill switch - maybe need another step on the check card in the office before having them sent in Share this post Link to post Share on other sites