nutter 0 Posted December 6, 2012 my cutter is scaling my files up to the wrong size - process= ill.5 writing an ill.3 .eps, open in signcut, reading correct dimentions then in preview mode lists dimentions larger then cuts file larger than designed wasting vinyl like mad!!! make it stop? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted December 6, 2012 are you sure you have it on the correct measurement? Metric or inches? Calibrate... Use pen and paper until you get it figured out and stop wasting vinyl. Share this post Link to post Share on other sites
nutter 0 Posted December 6, 2012 weather it is metric or inches it is coming out LARGER than the file is. and yes it is on inches everywhere. it's about 130% larger (on something that is 4.5"). could it be that out of whack? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted December 6, 2012 In cutter set up, In Sign cut there is: calibrate cutter size.. Try that Share this post Link to post Share on other sites
nutter 0 Posted December 6, 2012 thanks! it was way off before calibration, minor ajustment, now it is right on. no more wasting vinyl - cheers! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted December 6, 2012 Great,, glad you got it. Your welcome.. Share this post Link to post Share on other sites