heritagedesigns 0 Posted November 27, 2012 It's been a while since I have had to do this. I have SignBlazer installed and put in my CD to install the drivers for the cutter. I am not sure if the drivers are installing or not. Anywho, when I go to cut I get an error that says, "Cannot open the output device. Error initializing cutter." I get this error on my old pc when I forget to plug the cutter in, so I'm guessing that the new PC is not picking up the cutter. Any suggestions? New PC has Windows 8. I have a PCUT Creation CTN630 Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 27, 2012 start here http://start.uscutter.com/ Share this post Link to post Share on other sites
heritagedesigns 0 Posted November 27, 2012 You saved my life! I had been looking for something. The instructions the cutter came with are old and really don't make much sense. Thanks so much! Share this post Link to post Share on other sites
heritagedesigns 0 Posted November 27, 2012 Any suggestions on getting my old SBD files transferred over from the old computer? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 27, 2012 Your welcome, glad you got it,,,,save files to. Flash drive, external hard drive.. (depending on how many you have). send them in emails. Share this post Link to post Share on other sites
carson21 0 Posted January 10, 2013 on the drivers install there is no windows 8 if I have windows 8 and click on windows 7 will the drivers work ok thanks for your help Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted January 10, 2013 what have you got to lose, by trying it? It is not going to hurt anything. There are others using Windows 8,, But no reason that it has to be on a fancy computer, You can run a vinyl cutter back on XP, better. Share this post Link to post Share on other sites
