Binford 53 Posted November 23, 2012 Okay my SC Plotter i send the design to the plotter and the the head moves over to the media starts to cut and just keeps going over the same spot over and over again maybe after 40 or so passes it will move to the next part of the Design . i have tryed USB and Serial and 2 diff Computers all options i have tryed still do it i have reset the plotter 100 times unplug it for a long time still same thing its been grounded for pretty much since i had the thing and always worked. Has anyone else had this same issue ?? is it that chip maybe went bad? i have to replace it ?? Yup i am lost .. So if anyone has any info sure would love some help .. I even made a video of it doing it but for some reason my phone wont upload .. so maybe later i can add that video . Much thanks Share this post Link to post Share on other sites
Binford 53 Posted November 23, 2012 Plotter going over the same pattern Share this post Link to post Share on other sites
piscespokerbrat 80 Posted November 23, 2012 You try a different file? Maybe the design is doubled up? Share this post Link to post Share on other sites
Binford 53 Posted November 23, 2012 You try a different file? Maybe the design is doubled up? Yeah its a single file ... thanks Piscespokerbrat Share this post Link to post Share on other sites