j4str 9 Posted November 14, 2012 ive been experimenting with getting the warp correct for my cups and shot glasses. Using adobe illistrator, ive found a 10% warp for my glasses and 23% for the shot glasses. Im wondering, will 10 percent always work, or is it going depend on the width of the graphic and size of it? Share this post Link to post Share on other sites
BLAZZ 1 Posted November 15, 2012 I would think that % will be from the size of the graphic. but if its a % from preset work space it will be the same. Share this post Link to post Share on other sites
j4str 9 Posted November 15, 2012 yes, youre right. I just figured it out after you said that. If its only an inch wide it wil barely need any % but if its 5" wide it needs a much higher %. Is there any easy way to calculate it? Share this post Link to post Share on other sites
Jay2703 704 Posted November 15, 2012 You can use this calculator: http://www.i-logic.com/conecalc.htm For Radius B, enter the radius where you want to put your text. The Small Radius in the results will be the curve you want to shape your text to: Share this post Link to post Share on other sites
