MZ SKEETER 4,709 Posted November 14, 2012 Are you using the EFFECTS of Flexisignpro to set up your design for contour cutting first? You must. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 14, 2012 PM sent. Goodluck Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 14, 2012 I appreciate your help. sooo much. I am so tired of wasting my time trying to figure this out on my own your welcome, hope you get it. Share this post Link to post Share on other sites
Imlost21 1 Posted November 14, 2012 thank you for the help, sorry late to say ...Been bisy watching vids, lol, still trying with no luck. I know i will get it sooner or later, I was just hoping for sooner. thank you again Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 14, 2012 thank you for the help, sorry late to say ...Been bisy watching vids, lol, still trying with no luck. I know i will get it sooner or later, I was just hoping for sooner. thank you again Your welcome, so what are you doing wrong that it doesn't work? What is not working? Share this post Link to post Share on other sites