thenbrhd1 0 Posted November 12, 2012 I have downloaded a trial of signcut and bought a serial to usb cord. i think i have downloaded the drivers and installed them but i am not completely sure.. it was asking me to use telnet? well when i try and cut an .ai file the plotter does nothing.. i am completely lost. can someone please give me a discriptive how to. thank you Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 12, 2012 start here and work thru the instructions. http://start.uscutter.com/ Share this post Link to post Share on other sites