dyndes 1 Posted November 9, 2012 Does anyone have any insight as to why I must restart the PC after every job sent to the plotter? (Flexi 7.5, Win XPsp3, Serial to USB, Seiki SK-870) This issue just started happening over the past 3-4 days. Though, it would happen intermentently over the past 8-9 months, once a week or so. I run about 50 jobs a week. It was annoying before, and now it's costing money/time. *update* When I attempt to send the second job to the plotter (after the first one has completed) the Production Manager says 'cutting... 0%' and remains at zero percent. Share this post Link to post Share on other sites
mopar691 281 Posted November 9, 2012 When I was using my seiki i used the desay/master driver. Maybe try that Share this post Link to post Share on other sites
dyndes 1 Posted November 9, 2012 How do I determine my current driver? Is it the name that is listed under device manager for the port? I didnt make notes when I was installing them because I wasnt sure that it was going to work until it did. I believe the driver I used was Prolific Serial to USB. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 9, 2012 How do I determine my current driver? Is it the name that is listed under device manager for the port? I didnt make notes when I was installing them because I wasnt sure that it was going to work until it did. I believe the driver I used was Prolific Serial to USB. When you set up Flexi, production manager> add cutter, is where you list your cutter driver...Brand > Model. Prolific is the USB to serial cable driver. Share this post Link to post Share on other sites