inkuyo 8 Posted November 3, 2012 Here is a little video I did with a time lapse of weeding a project for a shirt. 2 Share this post Link to post Share on other sites
strycnine 23 Posted November 3, 2012 How does the Easy Weed do on smallish text? Share this post Link to post Share on other sites
Jay2703 704 Posted November 3, 2012 I like the video but you should have used a different color vinyl or background so it could be seen better. Strycnine, how small of text are you talking about? Share this post Link to post Share on other sites
strycnine 23 Posted November 3, 2012 Maybe 1/2 inch or close to it. Share this post Link to post Share on other sites
mb20music 760 Posted November 3, 2012 I have cut around 1/4" text on Easyweed and it is just like cutting on sign vinyl so yes, cutting small text with Easyweed is fine assuming of course your equipment is capable of cutting small text. Share this post Link to post Share on other sites
inkuyo 8 Posted November 3, 2012 I will make one with a different color. Pretty cool program on android called 'lapse it'. That was my first video. Share this post Link to post Share on other sites
Jay2703 704 Posted November 3, 2012 Because of the sticky backing it's easier than cutting Sign Vinyl. 1/2" should be no problem at all. I can do much smaller the problem is seeing where the cuts are. Share this post Link to post Share on other sites
strycnine 23 Posted November 3, 2012 Ok, thanks for the info. Share this post Link to post Share on other sites
GreenTech 3 Posted November 8, 2012 How does the Easy Weed do on smallish text? Hope this is a help. Maybe I attempted to cut this so small because I didn't know any better! Share this post Link to post Share on other sites
Jay2703 704 Posted November 8, 2012 I think you could go a lot smaller that that. Looks like your offset could use adjusting. Share this post Link to post Share on other sites
mfatty500 454 Posted November 8, 2012 Here is some small text http://forum.uscutter.com/index.php?app=core&module=attach§ion=attach&attach_rel_module=post&attach_id=87463 Share this post Link to post Share on other sites
GreenTech 3 Posted November 8, 2012 I think you could go a lot smaller that that. Looks like your offset could use adjusting. What is offset? I have a creation P-Cut and signblazer. Thanks. Share this post Link to post Share on other sites
Jay2703 704 Posted November 8, 2012 The tip of the blade is not in the center so the offset compensates for it. Think of towing a trailer, you have to take corners wider so the trailer doesn't go over the curb. Offset does the same thing. the package your blade came in should have an offset default setting on them. (Usually .25mm for a 45 Degree blade) It is set in SignBlazer in the cutter Setup. If you aren't getting square corners adjust it .01mm at a time until you get the best results. See the image below to help you dial it in. I'm guessing from your picture, yours is still set at 0. 2 Share this post Link to post Share on other sites
mr300s 1,272 Posted November 9, 2012 this is small right Scott 1 Share this post Link to post Share on other sites