Rob@MM 1 Posted November 1, 2012 My MH cuts like garbage. Imagine that right? I've read through more threads than I care to but didn't really find what I'm looking for. My cutter cuts 90% of what I do just fine. Where the problem is this. Lines don't match up with circles or text. But not all circles or text. It has nothing to do with the file I can assure you. I tried adjusting the pinch rollers several times, I tightened the drive belt. Open to any other suggestions. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted November 2, 2012 what software are you using? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted November 2, 2012 It's hard to tell from the p;ic but are the cuts not lining up, or just not connecting,as if they are just short of finishing? Share this post Link to post Share on other sites
Rob@MM 1 Posted November 2, 2012 Not lining up. It has nothing to do with the file. Everything worked fine during the first 10 000 decals I made. Now it does this on cirlces, text, boxes etc... Share this post Link to post Share on other sites
vinylmotivations 143 Posted November 2, 2012 It almost looks as if the offset was changed. Also, Check your blade with a magnifying glass and see if maybe the tip broke off. This can cause this as well. Share this post Link to post Share on other sites