CarterMarkham 18 Posted October 29, 2012 I have an LP II built by LiYu. It is over cutting in some areas. I have not adjusted any offset because I am not sure where to even start. Speed is 200mm/s pressure is 400g (Any lighter on the pressure and it wont cut) Blade is set correctly. Connected via Serial. 1 Share this post Link to post Share on other sites
Jay2703 704 Posted October 29, 2012 What software are you using? In SignBlazer it's in the cutter setup. Start at .25 and go from there. Share this post Link to post Share on other sites
CarterMarkham 18 Posted October 29, 2012 SignCutPro. It was set to 0.0098 and I changed it to 0.0000 and there was no noticeable difference. This is the "B" with the offset set to 0.25 Share this post Link to post Share on other sites