Megaworkz

Pcut 630 Cuts but LCD blank or boxes

Recommended Posts

Went out to the shop today powered up the computer then the Pcut 630. LCD is blank or has a few boxes. However it still cuts fine any ideas what the problem is?

  • Like 1

Share this post


Link to post
Share on other sites

No, sorry... But there used to be a special support topic on the USC web site (FAQ I think) that specifically metioned this problem. Although I think it had to do with the MH series, but may still be similar... Try a search either in the dorum or on the USC support site unless someone else chimes in with an answer.

Share this post


Link to post
Share on other sites

Yeah I've seen the FAQ. It doesn't apply to my problem. It's the kill switches on the sides to keep from damaging the motors. It does make to lcd go blank but also shuts the motors down. Mine still cuts I just can't see to make adjustments. I could deal with that if I didn't need to make pressure changes for T-Shirt vinyl.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now