Hornnumb2 2 Posted October 24, 2012 I need to cut a 10 foot piece of vinyl, what is the best way to load it? I have a been pulling out about 6 foot and watching it go back in to make sure its straight. Any Tips? Thanks Michael Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted October 24, 2012 I need to cut a 10 foot piece of vinyl, what is the best way to load it? I have a been pulling out about 6 foot and watching it go back in to make sure its straight. Any Tips? Thanks Michael Not many worries with a Graphtec. I barely pay any attention to it loading. Just make sure the above wheels are spaced evenly the same distance from the edge of the vinyl. prefeed and go. The Graphtec puts tracking marks in the vinyl to follow, The Graphtecs I know about have prefeed. So prefeed it 10 feet. or whatever you order is. Then it will go the 10 ft and go back to start. Then cut. I have cut 16ft and no problem. You don't state what model of Graphtec you have I am stating on a Graphtec CE5000, which I do know about it. and also a FC7000-MK-75 Share this post Link to post Share on other sites