Sign in to follow this  
htrowrod

FlexiSign question

Recommended Posts

I purchased a used machine and have Flexisign 8. I have cut out a few things and it worked really well. I have this one file and it starts cutting and at about 18% the cutter and software stop and the cutter head goes back to home and sits there.

Only on this one file so far. Any thing to try?

Bruce

  • Like 1

Share this post


Link to post
Share on other sites

You don't state what machine, put would guess it is on a USB connection. Put it on a Keyspan adapter,,and be done with it. If on a stand, ground the cutter to the stand, if static, put some dryer sheets in vinyl roll.

Also. If you raise, the blade up so that it does not touch the vinyl while cutting... will it complete the project? If so, most likely static.

Share this post


Link to post
Share on other sites

I have a Rohs(chinese) cutter. Yes, it is hooked up with a usb connection. I took the knife completely out and it still does the same thing. I think there is something with the file.

Bruce

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this