xtommypaynex 0 Posted September 12, 2012 hello, I am a newbie to vinyl cutting and I have a copam 3050 and am having a problem with drag lines thru my image cause the carriage wont go back up after the cut has started. The blade is not set too far out, first thing i tried. you can watch it cut and once it goes down for the start of the cut it never goes back up. any help or advice? Thank Tom Share this post Link to post Share on other sites
mb20music 760 Posted September 12, 2012 Did you buy the cutter new? if so I would call or start a support ticket with USCutter Share this post Link to post Share on other sites
xtommypaynex 0 Posted September 12, 2012 Yes a few months ago, I called us cutter yesterday and then waited all day for the specialist to call me back, which he never did. Share this post Link to post Share on other sites